Learn about the 3 ring system.

3-RING RISER RULES

• 1.   The riser(s) must break before jamming.
• 2.   The riser(s) must break before any other part of the harness is damaged.
• 3.   Both risers must release simultaneously under a load of up to 6 G’s, with a pull force of under 22 pounds.

 

A. There should be no gap between the outside edge of the harness ring and the small ring attachment tape.

B. The white loop should be long enough so that you can pull the housing ending ½” past the outside edge of the riser webbing.

C. The metal housings should compress very little, but should move or stretch upward one inch above the riser grommet.

D. The cutaway cable should be Lolon F coated, 7x7 steel cable, lubricated every month with Silicone or Teflon.